Perhitungan Kapal Tanker Laju Prakarsa untuk mengetahui bobot besi yang akan di scrapt.
Perhitungan Kapal Tanker Laju Prakarsa untuk mengetahui bobot besi yang akan di scrapt.
Perhitungan Kapal Tanker Laju Prakarsa untuk mengetahui bobot besi yang akan di scrapt.
Deskripsi lengkap
OptiX OSN 7500 Product Overview(TDM)
Tanker Familiarization
Rancangan Anggaran Biaya Pembangunan Jetty 8000 DwtFull description
Midship TankerFull description
Tanker Familiarization
Full description
DocumentacionFull description
Technical Specification of 7500 DWT IMO II Chemical Tanker contacted parts made of seawater resistant material. The heater must be resistant to accidental heating up to the steam temperature without water inside the cooler. Heating capacity sufficient heat seawater from 15 degree to 90 degree while using the normal capacity of the boilers. Heater unit must exist in heater and condense cooler in series, complete automatic temperature regulating valve makes CLORIUS – SAMSON or equal. To be completed, strainers, steam trap, pressure relief valve on waterside, thermometers on seawater in and outlet, pressure meter for steam, and thermometers for outlet condense. The capacity of this system is designed so that the total steam production of main boiler system can be taken for heating up seawater. The wash water heater must be installed in the pump room. Installed in such way that the heater can be removed for inspection/cleaning. Water flow from the tank wash pump to be pr essed trough the heater into the washing line on deck. Also possible to by pass and shortcut the heater. Wash water heater.
High Pressure Cleaning System:
Ship to be provided separate high-pressure water cleaning system KARCHER or similar pump. pump to be feed with pressurized water from a hydrophore that uses industrial water. This system should be tested and demonstrated proper operation to buyer. High-pressure Cleaning Pump:
In the engine room to be installed a high-pressure pumps make KARCHER or equal. Pressure approximately 180 bars. This pump must be secured for running dry, switch on/off automatically when the trigger on spray gun is pulled. Lines, Hoses & Spray Gun:
Pump connected to a fixed High Pressure pipe over total length of cargo area.
Dimension 1 inch. Special
High pressure stainless steel quick connection coupling to be made near each tank-cover. System to be completed two hands held trigger operated spray guns. Length of high pressure hose sufficient to reach all part of tank and cargo deck.
After tank cleaning, the washed oily water in each cargo tank to be pumped by its own cargo pump to slop tank or to the tank washing tank on deck and to be deposited through to be discharged out of side by the pump from slop tank under oily water discharge monitor.(O.D.M.E.)
